Engineering Design and Drawing (ENGGMG5005)

Level: 
5
Credits: 
15 (0.125 EFTS)
Compulsory: 
Yes
Aim: 
To enable students to gain an understanding of engineering design, drawing practice and modelling in an applied context.
Pre-requisites / Co-requisites: 
Students must be admitted to the Bachelor of Engineering Technology (Civil) programme to enrol in this course. Pre-requisites: ENGG MG5003.
Timetable: 
Choose your class for this course from the option(s) below. You will need to attend all the sessions in that class to complete the course. Where more than one class number is shown, choose one of them and attend all sessions within that class number. (Note: If a class is held in different locations at the same time, you only need to attend all the sessions in one of the locations.)
There are no classes on public holidays.

Class: 5633

You need to attend all sessions of this class as listed below.

From – ToSessionDayTimeCampus (Room)
24 Jul 18 - 25 Sep 18 LectureTuesday09:30 - 12:30 Mt Albert (114-2011)
16 Oct 18 - 30 Oct 18 LectureTuesday09:30 - 12:30 Mt Albert (114-2011)

Class: 5634

You need to attend all sessions of this class as listed below.

From – ToSessionDayTimeCampus (Room)
25 Jul 18 - 26 Sep 18 LectureWednesday13:00 - 16:00 Mt Albert (112-1100)
17 Oct 18 - 31 Oct 18 LectureWednesday13:00 - 16:00 Mt Albert (112-1100)

Class: 5934

You need to attend all sessions of this class as listed below.

From – ToSessionDayTimeCampus (Room)
25 Jul 18 - 26 Sep 18 LabWednesday13:00 - 16:00 Mt Albert (114-2009)
17 Oct 18 - 31 Oct 18 LabWednesday13:00 - 16:00 Mt Albert (114-2009)
Note: This course is offered as part of Bachelor of Engineering Technology (Civil), Bachelor of Engineering Technology (Electrical).

Share on