Engine Management Systems (APTE6509)

Level: 
6
Credits: 
15 (0.125 EFTS)
Compulsory: 
No
Aim: 
To enable students to analyse and evaluate a range of specialised principles and applications in the management of vehicle engines
Pre-requisites / Co-requisites: 
Students must be admitted to the Bachelor of Applied Technology programme to enrol in this course. Restrictions: TTEC6310 and TTEC6314.
Topics include: 

Appropriate selection from following topics
Fuel systems
Fuel systems principles, operational characteristics, limitations. Mechanical and electronic, fuel delivery, key components, sequential and grouped systems,
diagnostic equipment, data interpretations, closed and open loop, reformatting of system.
Aftermarket injection systems, gasoline direct injection systems, design, circuits and auxiliary devices, electronic control, multiple carburettors, limitations, venturi effect, analysis and correction procedures.
Ignition systems
Fuel systems principles, operational characteristics, limitations. Historical developments, operation, contact point electronic, computer controlled engine management.
Pressure charging
Superchargers, turbochargers, pressure control, system componentry, service procedures, effect on engine and components, nitrous oxide system, ignition parameters. Comparisons and limitations.
Timetable: 
Choose your class for this course from the option(s) below. You will need to attend all the sessions in that class to complete the course. Where more than one class number is shown, choose one of them and attend all sessions within that class number. (Note: If a class is held in different locations at the same time, you only need to attend all the sessions in one of the locations.)
There are no classes on public holidays.

Class: 1072

You need to attend all sessions of this class as listed below.

From – ToSessionDayTimeCampus (Room)
26 Jul 18 - 27 Sep 18 LectureThursday08:30 - 12:30 Mt Albert (115-3016)
18 Oct 18 - 22 Nov 18 LectureThursday08:30 - 12:30 Mt Albert (115-3016)

Class: 1191

You need to attend all sessions of this class as listed below.

From – ToSessionDayTimeCampus (Room)
28 Feb 18 - 11 Apr 18 LectureWednesday13:00 - 17:00 Mt Albert (182-1002)
2 May 18 - 27 Jun 18 LectureWednesday13:00 - 17:00 Mt Albert (182-1002)

Class: 5247

You need to attend all sessions of this class as listed below.

From – ToSessionDayTimeCampus (Room)
27 Jul 17 - 28 Sep 17 LectureThursday08:30 - 12:30 Mt Albert (180-2044)
19 Oct 17 - 23 Nov 17 LectureThursday08:30 - 12:30 Mt Albert (180-2044)
Note: This course is offered as part of Bachelor of Applied Technology - Automotive Engineering.

Share on